Overview
• Arduino Pin-compatible
• Ethernet (W5500 Hardwired TCP/IP chip)
W5500 Ethernet shield is designed using the WIZnet W5500 chip. Please click the link for the further information about W5500. It supports both 3.3V & 5V. This Ethernet Shield is compatible with Arduino and ARM mbed Platform.
Available Board List
– Arduino board (e.g. the Uno, Mega, Due)
– Arduino Leonardo
– Seeeduino v3.0 : Based on Arduino Duemilanove
Feature
• Suppport 3.3V / 5V
• High Speed Ethernet controller W5500 chip
• SPI interface
• Internal 32Kbytes Tx/Rx buffer
• 10/100 Ethernet PHY embedded
• Support Auto Negotiation (Full / Half duplex, 10 / 100-based)
• Hardwired TCP/IP Protocols : TCP, UDP, ICMP, IPv4, ARP, IGMP, PPPoE
• User Selectable GPIO pin
• Support SD-card slot for storage
• Support I2C, UART interface
Hardware Configuration
• RJ-45 with Transformer : Ethernet Port
• W5500 : a hardwired TCP/IP Ethernet Controller
• RESET : Reset Ethernet shield and Arduino when pressed
• SD-Slot : support Micro SD card in FAT16 or FAT32 ; (Please Read the Caution)
• I2C : I2C interface
• UART : UART interface
Be the first to review “W5500 Ethernet Shield”